• <button id="te2zc"><acronym id="te2zc"><input id="te2zc"></input></acronym></button>
    <tbody id="te2zc"></tbody><em id="te2zc"><acronym id="te2zc"></acronym></em>
  • <dd id="te2zc"><noscript id="te2zc"></noscript></dd>
     歡迎訪問濟南科爾超聲波設備有限公司網站!

    專注生產工業用清洗設備

    讓工業清洗無難事

    電話

    業務咨詢電話:

    18663767799

    你所在位置: 首頁-新聞動態-新聞資訊-超聲波清洗機的使用要注意14個事項
    新聞資訊

    超聲波清洗機的使用要注意14個事項

    作者:guanli來源:http://www.a7f4.com/時間:2022-08-19

    超聲波清洗機使用操作規程簡單,清洗能力強,能夠對零件類,工具,家用首飾類等清洗消毒,不傷及產品。下面來講講超聲波清洗設備的使用什么。
    The ultrasonic cleaning machine has simple operation procedures and strong cleaning ability. It can clean and disinfect parts, tools, household jewelry, etc. without damaging the products. Let's talk about the use of ultrasonic cleaning equipment.
    (1)超聲波清洗機電源及電熱機電源須有良好接地裝置。
    (1) The power supply of ultrasonic cleaning machine and electric heating machine must be well grounded.
    (2)超聲波清洗機在槽中沒有水或溶劑時,千萬不要啟動,否則會造成空振,造成振動頭損壞或報廢。
    (2) Do not start the ultrasonic cleaning machine when there is no water or solvent in the tank, otherwise it will cause air vibration and damage or scrap the vibrating head.
    (3)有加熱系統的超聲波清洗機嚴禁無液時打開加熱開關。
    (3) It is forbidden to turn on the heating switch when there is no liquid in the ultrasonic cleaning machine with heating system.
    (4)禁止用重物(如鐵件)撞擊清洗機槽底,以免能量轉換機晶片受損。
    (4) It is forbidden to strike the bottom of the cleaning machine with heavy objects (such as iron pieces) to avoid damage to the wafer of the energy converter.
    (5)超聲波清洗機電源應單獨使用一路220V/50Hz電源,配裝2000W以上穩壓機。
    (5) One 220V / 50Hz power supply shall be used separately for the power supply of the ultrasonic cleaning machine, which shall be equipped with a voltage stabilizer above 2000W.
    (6)清洗機槽底要定期沖洗,不得有過多的雜物或污垢。
    (6) The bottom of the washing machine shall be washed regularly, and there shall be no excessive sundries or dirt.
    (7)清洗機操作過程中請勿將手指放入清洗槽中,否則會感到刺痛或者不適。
    (7) Do not put your fingers into the cleaning tank during the operation of the cleaning machine, otherwise you will feel tingling or discomfort.
    (8)每次換新液時,待超聲波起動后,方可洗件。
    (8) When changing the new liquid each time, the parts can be washed only after the ultrasonic wave is started.
    (9)采用清水或水溶液作為清洗劑,禁止使用酒精,汽油或其他腐蝕性強、易燃、易爆的液體作為清洗劑加入清洗機中,有可能造成火災等危險情況發生。
    (9) Clean water or aqueous solution shall be used as cleaning agent. It is prohibited to use alcohol, gasoline or other highly corrosive, flammable and explosive liquids as cleaning agents into the cleaning machine, which may cause fire and other dangerous situations.
    超聲波清洗設備
    (10)當需要用腐蝕性或揮發性強的清洗液時,可采用間接清洗的方法。即:首先在清洗槽內加水,再將所需清洗液倒入適宜的容機內并放入被清洗物,然后將裝有清洗液和清洗物的容機浸入清洗槽中,即可開始清洗工作。
    (10) When corrosive or volatile cleaning liquid is required, indirect cleaning method can be adopted. That is, first add water to the cleaning tank, then pour the required cleaning liquid into the appropriate container and put it into the object to be cleaned, and then immerse the container containing the cleaning liquid and the object into the cleaning tank to start the cleaning work.
    (11)超聲波清洗效果方式:超聲波清洗槽的溫度一般為30~50℃,根據不同的清洗對象正確選擇清洗劑。清洗劑一般分為水基(堿性)清洗劑、有機溶劑清洗劑和化學反應清洗劑。通常使用多的為水基清洗劑,根據被清洗物的污染程度和污垢性質,選用不同的清洗時間。
    (11) Ultrasonic cleaning effect mode: the temperature of the ultrasonic cleaning tank is generally 30 ~ 50 ℃, and the cleaning agent is correctly selected according to different cleaning objects. Cleaning agents are generally divided into water-based (alkaline) cleaning agents, organic solvent cleaning agents and chemical reaction cleaning agents. Usually, water-based cleaning agents are used, and different cleaning times are selected according to the pollution degree and dirt nature of the cleaned objects.
    (12)盡量避免長時間連續工作,一般不超過30分鐘為宜。每次使用完畢后應關機20分鐘以上再次開機使用。
    (12) Try to avoid long-time continuous work, generally no more than 30 minutes. After each use, turn off the machine for more than 20 minutes and then turn it on again.
    (13)在使用時,清洗槽內清洗或脫氣的溶劑不要放入過少,至少應在槽內1/2以上,一般在槽內2/3處適宜。
    (13) During use, the solvent for cleaning or degassing in the cleaning tank shall not be put too little. It shall be at least 1 / 2 of the tank and generally 2 / 3 of the tank.
    (14)使用環境不能太潮濕,避免水蒸氣等進入到機機內部損壞元機件。
    (14) The operating environment should not be too humid to prevent water vapor from entering the machine and damaging the components.
    超聲波清洗機已被廣泛地用于石油、化工、金屬、電鍍、膠、電子、機械、汽車等各工業部門以及醫藥、大專院校和各實驗室等。您有需求可以來我們網站www.a7f4.com咨詢了解。
    Ultrasonic cleaning machine has been widely used in petroleum, chemical, metal, electroplating, rubber, electronics, machinery, automobile and other industrial departments, as well as medicine, colleges and universities and laboratories. You can come to our website www.a7f4.com for consultation.