• <button id="te2zc"><acronym id="te2zc"><input id="te2zc"></input></acronym></button>
    <tbody id="te2zc"></tbody><em id="te2zc"><acronym id="te2zc"></acronym></em>
  • <dd id="te2zc"><noscript id="te2zc"></noscript></dd>
     歡迎訪問濟南科爾超聲波設備有限公司網站!

    專注生產工業用清洗設備

    讓工業清洗無難事

    電話

    業務咨詢電話:

    18663767799

    你所在位置: 首頁-應用行業-科學研究清洗設備
    應用行業

    科學研究清洗設備

    作者:admin來源:http://www.a7f4.com/時間:2018-07-16

    案例展示(圖1)

    接通水

    Turn on the water

    扣動噴槍桿上的扳機排除設備內的水或氣。

    Pull the trigger on the spray gun rod to remove water or air from the equipment.

    將設備電源開關處于開位置,扣動槍柄扳機即可。

    Turn the power switch of the equipment to the on position and pull the trigger of the gun handle.

    釋放噴槍扳機,并將扳機設置在安全鎖定位置,關閉電源開關,按上噴嘴。

    Release the trigger of the spray gun, set the trigger in the safe lock position, turn off the power switch, and press the nozzle.

    扣動噴槍桿上的扳機并保持以釋放在泵里生成的壓力,當轉換到"開"位置時,繼續保持扣動扳機狀態,直至噴出的水不帶泡沫為止。

    Pull the trigger on the spray gun lever and keep the pressure generated in the pump released. When changing to the "open" position, continue to pull the trigger until the water is out of foam.

    將噴槍桿上的噴嘴卸下,這樣做有助于排除泵內的空氣。

    Remove the nozzle from the spray gun rod to help remove the air from the pump.

    將高壓軟管接在噴槍桿和高壓超聲波清洗設備之間。

    Connect the high-pressure hose between the spray gun rod and the high-pressure ultrasonic cleaning equipment.

    將橡膠軟管接在供水系統和高壓超聲波清洗設備之間。

    Connect rubber hose between water supply system and high pressure ultrasonic cleaning equipment.